Microhardness testing instrument - picodentor HM500 is checked for quality by our expert professionals as per the DIN EN ISO 14577-1 standards. It works on indentation depth method in which indenter is continuously pressed into the material tested with an increasing test load, and then unloaded. This microhardness testing instrument - picodentor HM500 is widely demanded in different industrial applications. Furthermore, it is extensively used for bulk material and coatings thinner than 1 ¼m (0.04 mils).
Design
- High resolutions for load ( 1 ¼N) and distance (40 pm); PICONDENTOR can be used for a broad range of applications
- Motorized z-axis and fully automated surface detection for higher productivity
- Enhanced high resolution optical system with auto focus and multiple objective turret
- Custom granite structure for enhanced frame stiffness and low noise floor
- Minimal sample preparation due to large working area and open layout
- Measurement of dark surfaces without sample pretreatment
- Measure on the smallest structures and cross-sections with high precision programmable X/Y table with a repeatability of 0,5 ¼m
- Vickers, Berkovich, spherical and custom indentors are available
- Additional vibration damping through closed measuring chamber and active anti-vibration table
- Easy operation through the customizable WIN-HCU® Software
Typical areas of application are
- Hard material coatings, general
- Ultra thin DLC coatings
- Protective coatings on glass
- Soil-resistant coatings (sol-gel coatings)
- Coatings of PC hard disks and CDs
- Very thin paint coatings
- Ion implanted surfaces
- Nanocoatings for sensors
- Medical technology (e.g. Implants)
- Matrix effects in alloys
- Biological materials
- Ceramic materials
- Hardness determination on cross-sectioned specimens
- Plasma-applied coating systems